Just be sure to put all of your excludes
at the top of the seedfile.
Les Dickert
Verisign Consulting
>From: "Rauwers, Laurens" <rauwers@hitt.nl>
>Reply-To: IBM NetView Discussion <nv-l@tkg.com>
>To: IBM NetView Discussion <nv-l@tkg.com>
>Subject: [NV-L] ! sign in netmon seed file
>Date: Thu, 31 May 2001 15:03:35 +0200
>
>Hello list,
>running NV 6.0.1 on Solaris 2.7
>
>I put an interface group with a certain ip-addresses with the ! sign in the
>netmon seed file.
>It was the intention not to discover those interfaces, however they are
>detected and placed on the map.
>Is this a NetView problem, or do I make the wrong assumptions?
>
>I put it in the seed file as follows: !163.45.126.*
>Netmon runs with: -P -I -s<seed file> -l
>The topology/status discovering configuration: discover new nodes is
>disabled
>
>Any help is welcome
>
>Laurens Rauwers
>
>HITT, Holland Institute of Traffic Technology B.V.
>P.O. Box 717, 7300 AS Apeldoorn, The Netherlands
>Oude Apeldoornseweg 41-45, Bldg Y, 7333 NR Apeldoorn, The Netherlands
>
>Phone: +31 55 543 2588
>Fax: +31 55 543 2553
>E-mail: rauwers@hitt.nl
>World Wide Web: http://www.hitt.nl
>
>
>_________________________________________________________________________
>NV-L List information and Archives: http://www.tkg.com/nv-l
_________________________________________________________________
|