Jason,
By default, NetView works at layer 3 (IP), not down at layer 2. The new IBM
Tivoli Switch Analyzer product gives a start to Layer 2 but it still doesn't
draw you a map showing L2 connectivity. I think it might show you status
changes on switches on the map??? but not at a per-port level.
Cheers,
Jane
"Allison, Jason (JALLISON)" wrote:
> Netview 7.1.2
> AIX 4.3.3
>
> We have some serial ports not running IP, only Layer 2 MAC. How can I have
> these ports discovered in the Netview topology map? My desire is to
display
> port status changes on the topology map.
>
> Thanks,
>
> Jason Allison
> Principal Engineer
> ARINC Incorporated
> Office: (410) 266-2006
> FAX: (410) 573-3026
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: nv-l-unsubscribe@lists.tivoli.com
> For additional commands, e-mail: nv-l-help@lists.tivoli.com
>
> *NOTE*
> This is not an Offical Tivoli Support forum. If you need immediate
> assistance from Tivoli please call the IBM Tivoli Software Group
> help line at 1-800-TIVOLI8(848-6548)
--
Tivoli Certified Consultant & Instructor
Skills 1st Limited, 2 Cedar Chase, Taplow, Bucks, SL6 0EU, UK
Tel: +44 (0)1628 782565
Copyright (c) 2002 Jane Curry <jane.curry@skills-1st.co.uk>. All rights
reserved.
---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe@lists.tivoli.com
For additional commands, e-mail: nv-l-help@lists.tivoli.com
*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)