RE: [nv-l] ICMP polling

[DSullinger@dot.state.az.us]

Thank you James.  I see this is the settings for SNMP polling, but what about ICMP polling?

 

 

-----Original Message-----
From: James Shanks [mailto:jshanks@us.ibm.com]
Sent: Monday, October 27, 2003 9:41 AM
To: nv-l@lists.us.ibm.com
Subject: RE: [nv-l] ICMP polling

This is 
user-configurable Dean.  In SNMP Options on Windows or xnmsnmpconf on UNIX. 
 There you will find all the polling cycle variables.

James 
Shanks
Level 3 Support  for Tivoli NetView for UNIX and 
Windows
Tivoli Software / IBM Software Group

DSullinger@dot.state.az.us Sent by: owner-nv-l-digest@lists.us.ibm.com 10/27/2003 11:29 AM Please respond to nv-l

To:        nv-l@lists.us.ibm.com         cc:                 Subject:        RE: [nv-l] ICMP polling

When 
Netview reports a interface down in the event stream, how many ICMP
polls has 
it sent to make the determination that this interface is down and
how often 
does it do this?

Same question on SNMP, when a router is reported down in 
the event stream,
how many SNMP polls were made to determine it is down and 
how often does it
do this at what intervals?

Sorry, I remember this 
being asked in the group before and I have saved all
messages over the past 
three years I've been with the group, but I did a
search and couldn't find 
the thread where this was discussed.

--
Dean S.
Arizona Department 
of Transportation
Information Technology Group
Network Architecture 
Team