>From your map go to Edit > Modify/Describe > Map. Click on IP Map under
configurable applications and then on "Configure for this Map". In the field
"How should interface labels be shown" change it to default. Click verify,
OK, OK and you should be back at your map and the labels should now
be the descriptions.
Paul
On Thursday 13 November 2003 10:17, reamd@Nationwide.com wrote:
> I have done a demand poll. I have snmp to the device. I can snmpwalk it and
> it brings in the correct bitmaps when discovered. When you drill down to
> see the interfaces of the router. It will show all interfaces and there
> status, it just shows the interface IP address and not the interface
> description.
>
>
>
> James Shanks
> <jshanks@us.ibm.com> T
> To:
> nv-l@lists.us.ibm.com Sent by: cc:
> owner-nv-l@lists.us.ibm
> .com bcc:
> Subject:
> Re: [nv-l] Interface Discovery
>
>
> 11/13/2003 09:24 AM
> Please respond to nv-l
>
>
>
>
>
>
>
> Have you tried a demand poll?
>
> You won't get that information until a config poll is done: it requires
> SNMP. If you have a device on the map and no information about i in the
> databases, then your community string for that device is probably wrong.
>
> James Shanks
> Level 3 Support for Tivoli NetView for UNIX and Windows
> Tivoli Software / IBM Software Group
>
>
> reamd@Nationwide.com
> Sent by: To:
> owner-nv-l@lists.us.ibm.com nv-l@lists.us.ibm.com
> cc:
> Subject: [nv-l]
> 11/13/2003 09:11 AM Interface Discovery
> Please respond to nv-l
>
>
>
>
>
>
> Hi All,
> During discovery, netview discovers the device and interfaces.
> Instead of telling what type of interface it is (FastEthernet, Serial, ect)
> it gives me IP addresses. How do I change this. Thanks, Dave
>
> Netview 7.1.3
> AIX 5.1
|