Re: [nv-l] Incorrectly Built Binary

[Diane Benze <dbenze@us.ibm.com>]

Hi, Anvaj -

 

This is from the ITSA Version 1.3 Release Notes:

 

         When you start the Tivoli NetView Web console on the Red Hat Enterprise Linux^(R)

         Advanced Server 3.0 system, the following message is displayed:

   Incorrectly built binary which accesses errno or h_errno directly. 
   Needs to be fixed.
   AMU01048732W Layer 2 topology data is currently not available.

         You can ignore this message as it does not indicate any loss of functionality.

 

I'm not sure if this information was also in the FP2 release notes but, as the note says, functionality

isn't affected in any way, so you can ignore it.

 

Diane

 

___________________________________________________________________________________________

 

diane benze | ibm software group | tivoli netview cvt test | 919.224.1035 | dbenze@us.ibm.com

___________________________________________________________________________________________

 

Wednesday, July 20, 2005 9:49 AM
To: <nv-l@lists.us.ibm.com>
cc:
From: "Anvaj A B" <anvaj.aliyarukutty@ustri.com>
Subject: [nv-l] Incorrectly Built Binary

 

I am running Netview 7.1.4 FP2 on RH Linux 3.0

 

I am getting a message “incorrectly built binary which accesses errno or h_errno directly. Needs to be fixed” when ever I run an ov command like ov start, ovtopofix etc

 

Could any body tell me what is it related to?

 

Best regards,

 

 

 

Anvaj Aliyarukutty anvaj.aliyarukutty@ustri.com	721, Nila Technopark, Trivandrum Tel: +91 471 233 5777 ext: 8653 Fax: +91 471 252 7276 Cell: +91 944 772 8103