Hi,
Do you have more than one map? delete the object from ALL maps before
loading it again.
Regs
Colin M.
-----Original Message-----
From: owner-nv-l@lists.us.ibm.com [mailto:owner-nv-l@lists.us.ibm.com]
On Behalf Of Liu, David
Sent: 30 January 2006 15:25
To: nv-l@lists.us.ibm.com
Subject: [nv-l] Adding new device
Dear list,
Have searched the archive but not found the solution, need your help.
When I add new device into Netview, always get the error message
"ERROR: Could not add node 'hostname' to topology: Object marked new
already exists"
I tried several times with the method I use before (which worked for
most of these kinds of problem), create a smartset with only this device
in it and delete it. The device is then neither locate from the GUI nor
from the command: "ovobjprint | grep hostname". After that re-discover
it through putting it in the netmon.seed. Nothing happened for the whole
weekend. Using loadhosts command then get the above error. After the
loadhosts command, issue "ovobjprint | grep hostname" and get the
following:
10 Selection Name "hostname"
11 IP Hostname
"hostname"
Only this, no Ip address etc. cannot locate through GUI.
Can you give any hint?
NV7.1.4, FP03, SUN Unix.
Regards,
David
*********************************************************************************
This e-mail and its attachments, is confidential and is intended for the
addressee(s) only. If you are not the intended recipient, disclosure,
distribution or any action taken in reliance on it is prohibited and may be
unlawful. Please note that any information expressed in this message or its
attachments is not given or endorsed by An Post unless otherwise indicated by
an authorised representative independently of this message. An Post does not
accept responsibility for the contents of this message and although it has been
scanned for viruses An Post will not accept responsibility for any damage
caused as a result of a virus being passed on.
*********************************************************************************
|