RE: [NV-L] Demandpoll Problems

["Van Order, Drew \(US - Hermitage\)" <dvanorder@deloitte.com>]

Morning David,

 

Can you snmpwalk the device and/or confirm the device in question is SNMP supported? You can do that by checking the object properties.

 

HTH--Drew

---

From: Liu, David [mailto:david.liu@eds.com]
Sent: Wednesday, July 19, 2006 7:21 AM
To: Tivoli NetView Discussions
Subject: [NV-L] Demandpoll Problems

Dear list,

NV714, FP3, Solaris .  

Last week I posted a question regarding demandpoll problem (discovery). It was finally found that demoandpoll is not doing his job for all devices, not only for the discovery. When I issue demandpoll (from both GUI and command line), it only gives back the status of the interfaces and verify node name. No more checking interface table, arp cache, admin/oper status etc. as before. I did ovtopofix -A (brook after two hours) before that happened. Later I did ovtopofix with all the options individually (not the -A), it finished in half a hour.

But demandpoll is still not doing.

 Could someone help?  Thank you in advance.

Regards,
David

This message (including any attachments) contains confidential information intended for a specific individual and purpose, and is protected by law.  If you are not the intended recipient, you should delete this message. 

Any disclosure, copying, or distribution of this message, or the taking of any action based on it, is strictly prohibited. [v.E.1]

_______________________________________________
NV-L mailing list
NV-L@lists.ca.ibm.com
Unsubscribe:NV-L-leave@lists.ca.ibm.com
http://lists.ca.ibm.com/mailman/listinfo/nv-l (Browser access limited to 
internal IBM'ers only)