nv-l
[Top] [All Lists]

Re: Can Netview monitor circuits?...

To: nv-l@lists.tivoli.com
Subject: Re: Can Netview monitor circuits?...
From: Gord Michaels <gord_michaels@HOTMAIL.COM>
Date: Mon, 20 Sep 1999 06:16:19 PDT
Thankyou for the response.

I did some looking and I found the following two traps on the Cisco site:

CISCO-ICSUDSU-MIB-V1SMI.my (added in 11.0(5), supported on 2524 and 2525)

ciscoICsuDsuT1LoopStatusNotification TRAP-TYPE
-- Reverse mappable trap
    ENTERPRISE ciscoICsuDsuMIBNotificationPrefix
    VARIABLES {
        ciscoICsuDsuT1LoopStatus }
--  Status
--    mandatory
    DESCRIPTION
        "Indicates a change in T1 Loop Status."
    ::= 1

ciscoICsuDsuSw56kLoopStatusNotification TRAP-TYPE
-- Reverse mappable trap
    ENTERPRISE ciscoICsuDsuMIBNotificationPrefix
    VARIABLES {
        ciscoICsuDsuSw56kLoopStatus }
--  Status
--    mandatory
    DESCRIPTION
        "Indicates a change in Sw56k Loop Status."
    ::= 2


My question is, can these traps be used for all Cisco Routers?? I am
referring to the statement above...

(added in 11.0(5), supported on 2524 and 2525)

I am not sure if these two traps are just the 2524 and 2525 or for all Cisco
Routers.

Has anyone has any experience with these traps??

Thanks in Advance,

Gord Michaels.


>From: "Waddle, Duane" <DWaddle@COMDATA.COM>
>Reply-To: Discussion of IBM NetView and POLYCENTER Manager on NetView
>        <NV-L@UCSBVM.ucsb.edu>
>To: NV-L@UCSBVM.ucsb.edu
>Subject: Re: Can Netview monitor circuits?...
>Date: Thu, 16 Sep 1999 13:21:13 -0500
>
>With a manageable CSU/DSU, Netview has visibility there.  For example, I
>use
>an Adtran Smart-16e CSU/DSU shelf -- it will send a trap when a circuit
>loses carrier, for example.  It will also let me poll it for T-1
>performance
>counters, which you can collect and/or run thresholds against ;-)
>
>--D
>
>
> > -----Original Message-----
> > From: Gord Michaels [SMTP:gord_michaels@HOTMAIL.COM]
> > Sent: Thursday, September 16, 1999 1:11 PM
> > To:   NV-L@UCSBVM.ucsb.edu
> > Subject:      Can Netview monitor circuits?...
> >
> > Hello All.
> >
> > Except for detecting if a serial interface is down on a router, does
> > Netview
> > have any functionality for monitoring circuits, example a T1 on a HSSI??
> >
> > Any info appreciated.
> >
> > Gord.
> >
> > ______________________________________________________
> > Get Your Private, Free Email at http://www.hotmail.com

______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com


<Prev in Thread] Current Thread [Next in Thread>

Archive operated by Skills 1st Ltd

See also: The NetView Web