RE: [nv-l] problem with node not showing up on map

["DePhillips, Frank" <fdephillips@McLeodUSA.com>]

James,

        I have the holding area turned on so all new routers get placed in the holding area before I put them on the map.  I added four routers last week and this one did not show up.  I did a locate and the router was not found by name or ip address.  I just ran the ovobjprint command and looked for the ip address and name in the output and it was not found. I have one map that is running production monitoring and I'm currently running a new map to clean up placement of nodes.

        I just tried to create the router by adding a new object and it comes back with the object selection name already exists and is a different type.

        Any other way I can find this object and delete it?

Thanks

Frank

-----Original Message-----
From: James Shanks [mailto:jshanks@us.ibm.com]
Sent: Friday, March 28, 2003 8:48 AM
To: nv-l@lists.tivoli.com
Subject: Re: [nv-l] problem with node not showing up on map

How do you know it's not on the map?  Did you try Locate?
If Locate fails to find it, then print the database with ovobjprint,
"ovobjprint > ovobjprint.out", and examine the output.    If you find the
object it should have two fields, OVW Maps Exit and OVW Maps Managed and
they should both have at least  a value of 1.  Do they?   At the bottom of
the record will be entries for the IP Symbol List for each of your maps.
You should have at least one map, usually called "default", so you should
see at least one entry which says "default IP Symbol List" followed by
some number.   Is that there?  Do you have more than one map?

James Shanks
Level 3 Support  for Tivoli NetView for UNIX and NT
Tivoli Software / IBM Software Group

"DePhillips, Frank" <fdephillips@McLeodUSA.com>
03/28/2003 09:38 AM

 
        To:     nv-l@lists.tivoli.com
        cc:
        Subject:        [nv-l] problem with node not showing up on map

        I have added a node to the seedfile and run netmon -y and it does not show
up on the map.  If I try to create the node manually it will say node
already exsists.  How can I find this node or delete and recreate?
Thanks
Frank

NOTICE: This electronic mail transmission may contain confidential
information and is intended only for the person(s) named.  Any use,
copying or disclosure by any other person is strictly prohibited. If you
have received this transmission in error, please notify the sender via
e-mail.

---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe@lists.tivoli.com
For additional commands, e-mail: nv-l-help@lists.tivoli.com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)

NOTICE: This electronic mail transmission may contain confidential information and is intended only for the person(s) named.  Any use, copying or disclosure by any other person is strictly prohibited. If you have received this transmission in error, please notify the sender via e-mail.