That didn't help. What I meant to say earlier was that even when I run
/usr/bin/X11/X -vfb -n :2 I get the same result - the usage statement. I
should be able to run this from the command line w/o the & to test if this
is working. No dice.
Allie
|---------+---------------------------->
| | George deSocio |
| | <desocio@us.ibm.c|
| | om> |
| | Sent by: |
| | owner-nv-l@lists.|
| | us.ibm.com |
| | |
| | |
| | 12/15/2003 03:54 |
| | PM |
| | Please respond to|
| | nv-l |
| | |
|---------+---------------------------->
>-----------------------------------------------------------------------------------------------------------------------|
|
|
| To: nv-l@lists.us.ibm.com
|
| cc: (bcc: Allie M Hopkins/allie/LSU)
|
| Subject: Re: [nv-l] X11 vfb problem
|
>-----------------------------------------------------------------------------------------------------------------------|
edit startXvfb
make sure the & is the last character in the line; (in vi the cursor should
not go past the ampersand)
delete any following blank lines
That fixed it on my lab system
AIX only
Regards,
Geo.
George deSocio
IBM Americas Support - Distributed Network Management
Dept 46-E1ZA
IBM B660 CC102
HWY 54 & 600 Park Offices
Research Triangle Park, NC 27709
919-254-2259 (T/L 444) Fax: 919-543-7936 (T/L 441)
E-Mail: desocio@us.ibm.com
Expand your Tivoli product knowledge by participating in Support Technical
Exchange:
http://www-3.ibm.com/software/sysmgmt/products/support/supp_tech_exch.html
|