not sure how to enable the traps on your hp - usually, the setup options
will ask you to specify to whom snmp traps should be sent (the trap manager,
specified by ip address/hostname), and what types of traps to send; i.e.,
authentication failure, offline/online, etc. Can you telnet into the
printer and view/change config settings? If yes, is there a snmp option?
On the other hand, it's possible that the printer *is* sending traps, and
that netview is simply displaying them without writing them to a log file
(assuming this is possible.)
> -----Original Message-----
> From: Sharma, Sanjeev [SMTP:Sanjeev.Sharma@USA.XEROX.COM]
> Sent: Monday, April 05, 1999 11:17 AM
> To: NV-L@UCSBVM.ucsb.edu
> Subject: Re: HP printer TRAPS
>
> yes snmp is enabled and i can able to get any snmp object and snmpwalk
> also.
> sanjeev
>
> -----Original Message-----
> From: OGrant [mailto:OGrant@PEC.COM]
> Sent: Monday, April 05, 1999 11:01 AM
> To: NV-L@UCSBVM.UCSB.EDU
> Subject: Re: HP printer TRAPS
>
>
> Is it snmp enabled? Can you do a snmpwalk (hostname/ip address) on it?
>
> > -----Original Message-----
> > From: Sharma, Sanjeev [SMTP:Sanjeev.Sharma@USA.XEROX.COM]
> > Sent: Monday, April 05, 1999 10:42 AM
> > To: NV-L@UCSBVM.ucsb.edu
> > Subject: HP printer TRAPS
> >
> > I have Hp Laser Jet 6P printer which is connected to the network using
> > JetDirect EX plus(J2591A) and firmware version is E.05.12.
> > I tried to create all critical condition and other interface related
> > errors
> > but i couldn't able to get any trap in the trapd.log file. What should i
> > do
> > to get the traps from that printer or in other words does this printer
> > support traps.
> >
> > In the NetView, we have one settings entry for hpnp_printer:
> > 1.3.6.1.4.1.11.2.3.9.1
> > and registered(i think so) 5 different traps in the Trap Settings
> > application.
> > does anyone put some light on this issue.
> > thanks a lot for your help.
> > regards
> > sanjeev
|