yes you are quite right. I couldn't able to find out that place or entry
where i should go and tell the
printer about the management stations which are interestered in receiving
traps in NetView.
Does Netview take care of this stuff automatically(i don't thik so)?
i tried on telnet also but there is no entry related to traps.
any other clue....or do you know any other HP application to receive the
traps coming from HP printer.
thanka a lot.
regards
sanjeev
-----Original Message-----
From: OGrant [mailto:OGrant@PEC.COM]
Sent: Monday, April 05, 1999 11:30 AM
To: NV-L@UCSBVM.UCSB.EDU
Subject: Re: HP printer TRAPS
not sure how to enable the traps on your hp - usually, the setup options
will ask you to specify to whom snmp traps should be sent (the trap manager,
specified by ip address/hostname), and what types of traps to send; i.e.,
authentication failure, offline/online, etc. Can you telnet into the
printer and view/change config settings? If yes, is there a snmp option?
On the other hand, it's possible that the printer *is* sending traps, and
that netview is simply displaying them without writing them to a log file
(assuming this is possible.)
> -----Original Message-----
> From: Sharma, Sanjeev [SMTP:Sanjeev.Sharma@USA.XEROX.COM]
> Sent: Monday, April 05, 1999 11:17 AM
> To: NV-L@UCSBVM.ucsb.edu
> Subject: Re: HP printer TRAPS
>
> yes snmp is enabled and i can able to get any snmp object and snmpwalk
> also.
> sanjeev
>
> -----Original Message-----
> From: OGrant [mailto:OGrant@PEC.COM]
> Sent: Monday, April 05, 1999 11:01 AM
> To: NV-L@UCSBVM.UCSB.EDU
> Subject: Re: HP printer TRAPS
>
>
> Is it snmp enabled? Can you do a snmpwalk (hostname/ip address) on it?
>
> > -----Original Message-----
> > From: Sharma, Sanjeev [SMTP:Sanjeev.Sharma@USA.XEROX.COM]
> > Sent: Monday, April 05, 1999 10:42 AM
> > To: NV-L@UCSBVM.ucsb.edu
> > Subject: HP printer TRAPS
> >
> > I have Hp Laser Jet 6P printer which is connected to the network using
> > JetDirect EX plus(J2591A) and firmware version is E.05.12.
> > I tried to create all critical condition and other interface related
> > errors
> > but i couldn't able to get any trap in the trapd.log file. What should i
> > do
> > to get the traps from that printer or in other words does this printer
> > support traps.
> >
> > In the NetView, we have one settings entry for hpnp_printer:
> > 1.3.6.1.4.1.11.2.3.9.1
> > and registered(i think so) 5 different traps in the Trap Settings
> > application.
> > does anyone put some light on this issue.
> > thanks a lot for your help.
> > regards
> > sanjeev
|