Re: [nv-l] netview name lookup

["Christopher J Petrina" <cjp8@meadwestvaco.com>]

With regards to Leslie's note.    If I am using the Name of the Gateway and not the IP address of it would it not go in and resolve to the correct IP and therefore Selection name.  And if it does not and the gateway name is invalid what exactly will happen then?

Leslie Clark <lclark@us.ibm.com> Sent by: owner-nv-l@lists.us.ibm.com 12/22/2003 10:09 AM Please respond to nv-l

To:        nv-l@lists.us.ibm.com         cc:                 Subject:        Re: [nv-l] netview name lookup

A common area of confusion with the location.conf file gateway entries: you cannot put just any old address in there. The match will be done on the Selection Name that the router ends up with. 

Cordially,

Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit

"Christopher J Petrina" <cjp8@meadwestvaco.com> Sent by: owner-nv-l@lists.us.ibm.com 12/22/2003 09:29 AM Please respond to nv-l

To:        nv-l@lists.us.ibm.com        cc:                Subject:        Re: [nv-l] netview name lookup

This is how I would figure it did the Name resolution.  HOwever with Netview running on an AIX box, my UNIX guru's have come to tell me that name resolution is only done via a DNS server from AIX.  AIX cannot be configured to use the /etc/hosts file for resolution.   We ahve a DNS server that it attaches to.   And your answer is what I was looking for 

Thank you 
Chris Petrina

Jane Curry <jane.curry@skills-1st.co.uk> Sent by: owner-nv-l@lists.us.ibm.com 12/20/2003 06:57 AM Please respond to nv-l

To:        nv-l@lists.us.ibm.com       cc:               Subject:        Re: [nv-l] netview name lookup

NetView himself has no name-to-address resolution mechanism - he uses 
whatever the host Operating System uses.  That is, if all you have is a 
hosts file with the NetView box in it, everything else will have IP 
addresses as labels.  It is strongly recommended that you have a 
reliable DNS employed by the NetView system (preferably with the NetView 
system acting as a caching / secondary DNS server).

Cheers,
Jane

Christopher J Petrina wrote:

>
> how does netview look attempt to determine the name of a device.
> i.e. in my location.conf file I am using names in place of IP 
> addresses for my gateways.  How does Netview resolve the name on a AIX 
> box? 


-- 
Tivoli Certified Consultant & Instructor
Skills 1st Limited, 2 Cedar Chase, Taplow, Bucks, SL6 0EU, UK
Tel: +44 (0)1628 782565
Copyright (c) 2003 Jane Curry <jane.curry@skills-1st.co.uk>.  All rights reserved.



________________________________________________________________________
This email has been scanned for all viruses by the MessageLabs SkyScan
service._______________________________________________________________