I had that problem yesterday on a demo box that nvserverd.log was
reporting tec_create_handle fail messages (NV 7.1.4/Solaris 2.8, TEC
3.9/w2k). Restarting NV didn't clear the error, but rebooting the box
did (I ran out of time!) - I'm not happy about reboots clearing things
myself! I'd previously had a NV 7.1.4/w2k machine sending events
happily to the same TEC - both installs are straight off the cd (apart
from switching off autotrace & FFDC).
I've seen that error before (NV 7.1.4/Linux RH, TEC 3.9 Linux RH), but
again had no time to look properly. I didn't touch the SCE settings,
but will do next time I get a chance to see if there is a pattern.
K
------------------------------------------------------------------------
---
Karl Prinelle
Consultant
Elyzium Ltd
Mobile: +44 (0)7813 189198
E-mail: karl.prinelle@elyzium.co.uk
Slough Office, Church Street, Slough, SL1 1PJ. Tel: +44 1753 515000,
Fax:+44 1753 515017
Head Office, 12 Queensbrook, Bolton, BL1 4AY. Tel: +44 1204 528628, Fax:
+44 1204 534678
For further information, please visit our website at www.elyzium.co.uk
------------------------------------------------------------------------
---
Elyzium Disclaimer:
This email transmission is confidential and intended solely for the
person
or organisation to whom it is addressed. If you are not the intended
recipient, you must not copy, distribute or disseminate the information,
or
take any action in reliance of it. Any views expressed in this message
are
those of the individual sender, except where the sender specifically
states
them to be the views of any organisation or employer.
If you have received this message in error, do not open any attachment
but please notify the sender (above) deleting this message from your
system.
Please rely on your own virus check no responsibility is taken by the
sender for any damage arising out of any bug or virus infection.
------------------------------------------------------------------------
---
-----Original Message-----
From: owner-nv-l@lists.us.ibm.com [mailto:owner-nv-l@lists.us.ibm.com]
On Behalf Of Jane Curry
Sent: 15 January 2004 07:28
To: nv-l@lists.us.ibm.com
Subject: Re: [nv-l] 7.1.4 and TEC 3.7
Hi Chris,
Look at /usr/OV/conf/tecint.conf. I think you will find a couple of
lines at the end that enable the State Correlation feature. I have
commented these lines out of tecint.conf and run nvtecia -reload to
have nvserverd take note. That got things running for me.
Cheers,
Jane
Christopher J Petrina wrote:
>
> I upgraded my AIX Netview from 7.1.3 to 7.1.4. I have enabled
> forwarding of events to TEC, however none of the events are being
> forwarded.
> trapd shows the events coming in but how can I verify or check to see
> if tey are being sent out to TEC?
>
> TIA
> Chris Petrina
--
Tivoli Certified Consultant & Instructor
Skills 1st Limited, 2 Cedar Chase, Taplow, Bucks, SL6 0EU, UK
Tel: +44 (0)1628 782565
Copyright (c) 2004 Jane Curry <jane.curry@skills-1st.co.uk>. All rights
reserved.
|