RE: [nv-l] locations

[Leslie Clark <lclark@us.ibm.com>]

Yes, you can do it without rediscovery,
but you must make a new map, as in 'File..New Map'.  Without efixes
on 7.1.4 there are some problems with this. Get the efix for APAR IY48698.
 In fact you ought to call Support and ask for the latest recommended
efixes. I hear they are getting close to the first fixpack for 7.1.4, so
there are  a few good ones you might want to put on. 

And even without a new map, nodes and
networks that are discovered later will be placed according to the location.conf
that was in place when you started the Netview interface. 

Cordially,

Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit

Marcos Antonio Pezzutti Filho <pezzutti@banespa.com.br>
Sent by: owner-nv-l@lists.us.ibm.com

04/10/2004 03:49 PM

Please respond to
nv-l

To	"'nv-l@lists.us.ibm.com'" <nv-l@lists.us.ibm.com>
cc
Subject	RE: [nv-l] locations

Hi Mario,
 
You can modify the file and stop
and restart netview.
Then all new nodes and routers
are put on the designated location.
 
Marcos Pezzutti
-----Original Message-----
From: Mario Behring [mailto:mariobehring@yahoo.com]
Sent: Saturday, April 10, 2004 1:44 PM
To: nv-l@lists.us.ibm.com
Subject: [nv-l] locations

Hi list,
 
Can I configure a location.conf file in a NV 7.1.4 running
on a AIX box after the initial discovery (a production box) ? I
mean, will NV put each discovered objet in its appropriate location container
? Or this can be done only at the initial discovery ?
 
Thanks.
 
Mario Behring
Tivoli Certified Consultant
IBM Brazil
55 19 2104-3006
55 11 8125-5598
mariob@br.ibm.com
mariobehring@yahoo.com

---

Do you Yahoo!?
Yahoo! Tax Center - File
online by April 15th